Garage door won't close: sensor repair in Morristown

A garage door that refuses to close is annoying, but it is the safety system doing its job.

Call (862) 362-2618

In short

If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Morristown realigns or replaces the sensors and tests the safety reverse.

Ceiling opener and torsion spring over a single garage door

Doors that won't close in Morristown

Morristown's houses around the Green and in the historic district often have carriage houses or small detached garages that were converted to automatic doors long after they were built. Sensor wire in those buildings is usually surface-run and easy to snag. In the newer attached garages out toward Convent Station and Washington Valley, the opener is busier and the cause is more often alignment: a bracket nudged by a bin, or a door whose close limit has drifted so it touches the floor and reopens.

The usual reasons a door reverses or stays open

  • Misaligned photo-eyes. A bin, a bike tire or a broom knocks one bracket a few degrees and the beam misses.
  • Dirt, cobwebs or condensation on a lens. The sensor sees it as an obstacle.
  • Low sun shining straight into the receiving eye. It happens at the same hour each day and clears up later.
  • Damaged sensor wire. Staples, rodents and corrosion all break the thin low-voltage wire.
  • Close limit or force out of adjustment. The door reaches the floor and the opener reads it as a collision.

Quick things to rule out

  • Is anything in the path of the beam, even a leaf or a cobweb?
  • Are both sensor lights lit and steady?
  • Does the problem only happen at one time of day? That points to sun in the sensor.
  • Is the wall control's lock or vacation button switched on? It disables the remotes.

Anything beyond that, including limit and force adjustment, is a job for a technician, because a wrong setting can stop the door from reversing when it should.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around Morristown

  • Burnham Park: Residential streets on the west side of town.
  • Convent Station: Township neighborhood of colonials near the rail station.

See the full Morristown service area.

Door stuck? Call before you try to force it.

Springs and cables hold a lot of tension. Don't lift the door by hand or keep pressing the opener; call and we'll book a technician.

Call (862) 362-2618
Call (862) 362-2618